Kontron AT8050 User Manual download pdf (Page 52)

36 AT8050

www.kontron.com

3.5.3 Installing an AMC

To install an AMC:

1 Remove the AMC filler panel.

2 Carefully engage the AMC into the card guide. Push the AMC until it fully mate with its connector. Secure

the AMC handle to the locking position.

3 In normal condition, the blue LED shall turn ON as soon as the AMC is fully inserted. It will turn OFF at the

end of the hot swap sequence.

3.5.4 Removing an AMC

To remove an AMC:

1 Pull out the handle to unlock the AMC.

2 Wait for the blue LED to turn on continuously.

3 Pull out the AMC using the handle.

3.5.5 Installing the RTM8050

To install the RTM:

1 Remove the filler panel of the slot.

2 Ensure the board is configured properly.

3 Carefully align the PCB edges in the bottom and top card guide.

4 Insert the board in the system until it makes contact with the CPU board.

5 Using both ejector handles, engage the board in the CPU board connectors until both ejectors are locked.

6 Fasten screws at the top and bottom of the faceplate.

3.5.6 Removing the RTM8050

To remove the RTM:

1 Unscrew the top and the bottom screw of the faceplate.

2 Unlock the lower handle latch.

3 Wait until the blue LED is fully ON, this mean that the hot swap sequence is ready for board removal.

4 Use both ejectors to disengage the board from the CPU board.

5 Pull the board out of the chassis.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 164 165

No comments

Kontron AT8050 User Manual Page 52