Kontron KTGM45-mITX User Manual Page 68

  • Download
  • Add to my manuals
  • Print
  • Page
    / 101
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 67
KTGM45 Users Guide
KTD-N0793-O Page 68
7.3.2 Advanced settings – IDE Configuration
BIOS SETUP UTILITY
Advanced
IDE Configuration
Options
Disabled
Compatible
Enhanced
<- Select Screen
|| Select Item
+- change option
F1 General Help
F10 Save and Exit
ESC Exit
Mirrored IDER Configuration [Disabled]
SATA#1 Configuration [Compatible]
Configure SATA#1 as [IDE]
SATA#2 Configuration [Enhanced]
Primary IDE Master : [Hard Disk]
Secondary IDE Master : [Not Detected]
Third IDE Master : [Not Detected]
Fourth IDE Master : [Not Detected]
Fifth IDE Master : [Not Detected]
Fifth IDE Slave : [Not Detected]
Hot Plug [Disabled]
AHCI Configuration
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
TA(PI) 80Pin Cable Detection [Host & Device]
JMicron 36x ATA Controller [Enabled]
v02.67+ (C)Copyright 1985-2009, American Megatrends, Inc.
Feature
Options
Description
SATA#1 Configuration
Disabled
Compatible
Enhanced
Disabled
Compatible
Enhanced
Configure SATA#1 as
IDE
RAID
AHCI
IDE
RAID
AHCI
SATA#2 Configuration
Disabled
Enhanced
Disabled
Enhanced
Note: When RAID shall be used in XP then use “Floppy_F6” driver (load RAID driver via Floppy Disk). The
RAID driver must be installed even if the OS shall be executed from a HDD not included in the RAID. When
XP Installation CD is started then after approx. ½ minute it will for a few seconds ask you to press <F6> for
special driver selection (do that). System will continue loading files but after a minute or so it will ask you to
press the <S>-key. Now load the Floppy Disk and press the <S> key. Select the ”Intel(R) ICH9M-E/M SATA
AHCI Controller". System will ask you for more special drivers, but just skip that by pressing <Enter>.
BIOS setup
Page view 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 100 101

Comments to this Manuals

No comments