Kontron KTQM67-mITX User Manual Page 22
- Page / 148
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
KTQM67 Users Guide
KTD-N0819-K Page 22
2.6 Power Consumption
In order to ensure safe operation of the board, the ATX12V power supply must monitor the supply
voltage and shut down if the supplies are out of range – refer to the hardware manual for the actual
power supply specification. Please note, In order to keep the power consumption to a minimal level,
boards do not implement a guaranteed minimum load. In some cases, this can lead to compatibility
problems with ATX power supplies, which require a minimum load to stay in regulation.
The KTQM67 board is powered through the ATX/BTX connector and ATX+12V connector. Both
connectors must be used in according to the ATX12V PSU standard. However the KTQM67/mITX also
supports single +12V via ATX+12V-4pin Power Connector, but power limitations apply to +5V, where
14x USB, LVDS panel or eDP panel, COM ports, LPT port and Frontpanel connector shares 9.5A.
ATX+12V-4pin power limitation is 145W, however more +12V power can be added via +12V and GND
terminals in the 24-pin power connector.
Warning: Hot Plugging power supply is not supported. Hot plugging might damage the board.
The requirements to the supply voltages are as follows:
Supply Min Max Note
VCC3.3 3.168V 3.432V
Should be ±4% for compliance with the ATX specification
Vcc 4.75V 5.25V
Should be ±5% for compliance with the ATX specification.
Should be minimum 5.00V measured at USB connectors
in order to meet the requirements of USB standard.
+12V 11.4V 12.6V
Should be ±5% for compliance with the ATX specification
–12V –13.2V –10.8V
Should be ±10% for compliance with the ATX specification
-5V -5,50V -4.5V Not required for the KTQM67 boards
5VSB 4.75V 5.25V
Should be ±5% for compliance with the ATX specification
Total System power example
I7-2710QE @ 2.10GHz, 1x 4GB Ram, 1x 500gb HDD, 1x DVD-ROM, PSU
Operation
Power Supplied via
ATX + 12V
12V Only
Windows 7 32bit Idle
33W
36W
Windows 7 32bit 3Dmark 2003
70W-88W
72W-96W
Windows 7 32bit Intel Thermal Load
111W
111W
Note: Listed power consumptions are inclusive 15 - 25W for PSU, HDD and DVD.
More detailed Static Power Consumption
On the following pages the power consumption of different boards in different configurations are listed.
For each configuration the power consumptions result are listed in 5 tables:
1- DOS, idle, mean
2- Windows7, Running 3DMARK 2005 & BiT 6, mean
3- S0, mean
4- S3, mean
5- S5, mean
Note: some S5 measurements have been carried out in two sub modes M3 and Moff. Only S5/M3 mode
maintains power to the circuits used for AMT and waking up the system via LAN, Keyboard and USB,
while both S5/M3 and S5/Moff maintain power to RTC, Power Button In circuit and CMOS data.
System Specification
- KTQM67 Users Guide 1
- Document revision history 2
- Copyright Notice: 2
- Trademark Acknowledgement: 2
- Disclaimer: 2
- Life Support Policy 2
- Services 3
- Warranty 3
- Contents 4
- Introduction 7
- 1 Installation procedure 8
- Installation procedure 9
- 2 System Specification 10
- 2.2 System overview 14
- 2.3 Processor Support Table 16
- 2.4 System Memory support 19
- 2.5.3 LVDS and DVI 21
- 2.5.4 Graphics Adapters 21
- 2.6 Power Consumption 22
- 3 Connector Locations 30
- 3.3 KTQM67/mITX - backside 31
- 3.4 KTQM67/Flex 32
- 3.5 KTQM67/Flex - backside 33
- 3.6 KTQM67/ATXP 34
- 3.7 KTQM67/ATXP - backside 35
- 4 Connector Definitions 36
- 5 IO-Area Connectors 37
- 5.2 Ethernet Connectors 39
- 6 Internal Connectors 43
- 6.6 USB Connectors (USB) 50
- 6.10 Audio Connectors 55
- 7.1 PCIe Connectors 66
- 7.2 PCI Slot Connectors 71
- Onboard/mating connector 74
- 9 System Resources 75
- 9.2 PCI Devices 76
- 9.3 Interrupt Usage 77
- 9.4 IO Map 78
- System Resources 79
- 10 BIOS 80
- 10.2 Advanced 81
- BIOS - Advanced 100
- 10.3 Chipset 118
- BIOS - Chipset 119
- 10.4 Boot 138
- BIOS - Boot 139
- 10.5 Security 142
- BIOS -Security 143
- 10.6 Save & Exit 146
- 11 AMI BIOS Beep Codes 147
- 12 OS Setup 148
Related products and manuals for Hardware Kontron KTQM67-mITX
Hardware Kontron KTQ67-FLEX User Manual
(137 pages)
(137 pages)
Hardware Kontron KTQ67-FLEX MED User Manual
(129 pages)
(129 pages)
Hardware Kontron KTQ77-FLEX User Manual
(141 pages)
(141 pages)
Hardware Kontron KTA75-FLEX User Manual
(90 pages)
(90 pages)
Hardware Kontron KTH81-mITX User Manual
(98 pages)
(98 pages)
Hardware Kontron KTLX800-pITX User Manual
(66 pages)
(66 pages)
Hardware Kontron KTD-S0018-A User Manual
(19 pages)
(19 pages)
Hardware Kontron pITX-SP User Manual
(67 pages)
(67 pages)
Hardware Kontron KTA55-pITX User Manual
(67 pages)
(67 pages)
Hardware Kontron KTT20-pITX User Manual
(52 pages)
(52 pages)
Hardware Kontron KTAM3874-pITX User Manual
(293 pages)
(293 pages)
Hardware Kontron pITX-E38 User Manual
(61 pages)
(61 pages)
Hardware Kontron KTHM65-mITX User Manual
(129 pages)
(129 pages)
Hardware Kontron KTHM76-mITX User Manual
(140 pages)
(140 pages)
Hardware Kontron KTT30-mITX User Manual
(38 pages)
(38 pages)
Hardware Kontron KTA70M-mITX User Manual
(88 pages)
(88 pages)
Hardware Kontron KTQM87-mITX User Manual
(110 pages)
(110 pages)
Midland G5 XT manuály
Uživatelské manuály a uživatelské příručky pro Komunikace Midland G5 XT.
Poskytujeme 1 manuály pdf Midland G5 XT ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comments to this Manuals