Kontron CP6004-SA User Manual download pdf (Page 30)

Introduction CP6004-SA

Page 1 - 12 ID 1052-8529, Rev. 2.0

D R A F T — F O R I N T E R N A L U S E O N L Y

Interfaces

Rear I/O The following interfaces are routed to the rear I/O connectors J3 and J5.

• COMA (RS-232 signaling) and COMB (RS-232 signaling); no buffer on

the rear I/O module is necessary

• 4 x USB 2.0

• 1 x CRT VGA, 2 x HDMI/DVI

• 1 x HDA

• 2 x Gigabit Ethernet (compliant with PICMG 2.16, R 1.0)

• 4 x SATA 3 Gb/s

• 4 x GPIs and 4 GPOs (LVTTL signaling)

• System write protection

The rear I/O connector J4 is optionally available and provides rear I/O inter-

connection to the PMC/XMC interface.

Gigabit Ethernet

Five 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces

based on one Intel® 82579LM Gigabit Ethernet controller and one Intel®

I350 quad-port Gigabit Ethernet controller:

• Three RJ-45 connectors on the front panel

• Two ports on the rear I/O (PICMG 2.16)

• Automatic mode recognition (Auto-Negotiation)

• Automatic cabling configuration recognition (Auto-MDI/X)

USB

Six USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):

• Two type A USB 2.0 connectors on the front panel

• Four USB 2.0 ports on the rear I/O interface

Serial Two 16C550-compatible UARTs:

• One RS-232 port on the front panel and routed to rear I/O, COMA

• One RS-232 port on the rear I/O, COMB

PMC PMC interface:

• Four onboard mezzanine connectors for connecting a standard PMC

module

• Up to 64-bit/66 MHz PCI or up to 64-bit/133 MHz PCI-X interface with

dedicated PCIe-to-PCI-X bridge

• Only 3.3V PCI signaling voltage

• Rear I/O supported through the CompactPCI connector J4 (optional)

• Supported voltages: 3.3 V, 5 V, +12 V, and -12 V

XMC XMC interface:

• One onboard XMC connector for connecting a standard XMC module

• Up to x8 lanes PCI Express 2.0 ports operating at 5 GT/s

• Rear I/O supported through the PMC connector (Jn4) to the

CompactPCI connector J4 (optional)

SATA Two SATA 6 Gb/s interfaces for:

• Up to 64 GB flash memory via an onboard SATA Flash module, or

• Onboard 2.5" HDD/SSD is supported in combination with the

MMADP-SATA01 module

• One standard SATA 6 Gb/s interface for the standard SATA connector

Four SATA 3 Gb/s ports accessible via rear I/O

Table 1-1: CP6004-SA Main Specifications (Continued)

FEATURES SPECIFICATIONS

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Kontron CP6004-SA User Manual Page 30

Comments to this Manuals

Related products and manuals for Hardware Kontron CP6004-SA